Candy TR 31 RUFA Instrukcja Użytkownika Pobierz pdf (Strona 10)

Burner’s body

Jet

9 GB

The appliances are regulated by the manufacturer for the type of gas indicated on the packing and on the label attached to the

appliance itself. If they are to be used with another type of gas, the appliance must be adjusted in the following way:

CHANGING THE GAS TYPE CAST IRON / STAINLESS STEEL / ENAMELLED STEEL HOBS

• CHANGING THE JETS

Each jet is designated by size.

To gain access to the jets :

• remove the pan supports,

• remove the burner cap and body,

• using the spanner supplied with the appliance, unscrew the jet,

• fit the correct jet for the type of gas to be used,

• secure the jet tightly,

• regulate the air ring,

• replace the burner body, cap and the pan support.

• REGULATE THE AIR RING

Regulating the air ring is important as it ensures the correct

combustion and enables the burners to work at maximum

efficiency.

It may be necessary to adjust this regulation according to

the conditions of your domestic gas supply.

The burner flame should be steady and with no red or yellow

points.

The air ring is located at the lengthening of the burner unit

which is fixed by a screw (see drawing).

If necessary :

• unscrew the screw that holds the air flow adjuster,

• set the correct distance according to the air adjuster

protrudes,

• secure the screw when the operation is completed.

By-pass screw for the hob burner

Never loosen

other screws!

Example: Ultra-Fast

burner

JETS

Propane Gas

G31 37 mbar

Burner Natural Gas

G20-20 mbar

G25-25 mbar

Butane Gas

G30 28-30 mbar

DC/UR (3,2 kW)

UR (3,5 kW)

R (2,5 kW)

SR (1,45 kW)

94x2

102x2

122

65x2

68x2

65x2

68x2

REGULATE THE AIR RING Quota X in mm

Propane Gas

G31 37 mbar

Burner Natural Gas

G20-20 mbar

G25-25 mbar

Butane Gas

G30 28-30 mbar

UR (3,2 kW)

Cast iron hob

UR (3,5 kW-3,2kW)

R (2,5 kW)

SR (1,45 kW)

Cast iron hob

SR (1,45 kW)

DC (3,2 kW)

Quota

Air regulation

Fixing screw

Quota

Air

regulation

Fixing

screw

• REGULATE THE FLAME

If you have changed the type of gas, it is important to verify the flame stability

at the minimum regulation.

To gain access to hob burner by-pass screws, remove the knobs from the

control panel.

a) Natural gas :

• simply loosen the screw.

• switch on the burner and turn the knob to minimum.

• Turn the by-pass screw until a low flame is visible. Turn the control knob

from minimum to maximum position to check that it is satisfactory.

b) Butane-propane gas :

The by-pass screw should be screwed fully home, without being locked.

Burner’s body

Jet

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Komentarze do niniejszej Instrukcji

Brak uwag

Candy TR 31 RUFA Instrukcja Użytkownika Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Piece Candy TR 31 RUFA